Variations in wave direction estimated using first and second order Fourier coefficients     

V. Sanil Kumar  N. M. Anand 《Ocean Engineering》2004,31(17-18):2105-2119

In most design applications such as alignment of the berthing structure and breakwater alignment, it becomes necessary to determine the direction of design wave. There are two different approaches to determine wave direction. One involves the use of first order Fourier coefficients (mean wave direction) while the other uses second order Fourier coefficients (principal wave direction). Both the average wave direction over the entire frequency range (0.03–0.58 Hz) and the direction corresponding to the peak frequency are used in practice. In the present study, comparison is made on wave directions estimated based on first and second order Fourier coefficients using data collected at four locations in the west and east coasts of India. Study shows that at all locations, the mean and principal wave directions for frequencies ranging from 0.07 to 0.25 Hz (±0.5 times peak frequency) co-vary with a correlation coefficient of 0.99 but at lower and higher frequencies, difference between the parameters is large. Average difference between the mean wave direction at peak frequency and the average over the frequency related to spectral energy more than 20% of maximum value is less, around 13°. Study shows that average difference in the sea and swell directions is around 39°.  相似文献   

Impact of Satellite Altimetry on Simulations of Sea Level Variability by an Indian Ocean Model     

S. K. Singh  Sujit Basu  Raj Kumar  Vijay K. Agarwal 《Marine Geodesy》2001,24(1):53-63

This article describes the impact of satellite altimeter data on the simulations of sea level variability (SLV) by a nonlinear reduced gravity model of the entire Indian Ocean. The model has been forced by 6-hourly analyzed wind stress data containing SSM/I observations and has been able to produce realistic circulation features. However, SLV values observed by Topex/Poseidon altimeter do not fit these simulations because of imperfect initial data. Hence an attempt has been made to initialize the model using altimeter data. The initialized model-generated SLVvalues have been compared with SLV derived by altimeter for monsoon as well as nonmonsoon months of 1996. Experimental runs have been performed for 10 days, 20 days, and one month. It has been found that the initialized model results on the final day of these experiments are in very good agreement with altimeter data of the same day. It is thus possible, in principle, to hindcast and forecast sea level variations in the time scale of 10 days to one month with the availability of good quality wind data for forcing the model and altimeter observations of sea level for initializing it.  相似文献   

On the application of similitude to installation operations of offshore steel jackets     

Subroto Kumar Bhattacharyya 《Applied Ocean Research》1984,6(4):221-226

The role of similitude in scaled simulation of major installation operations of offshore steel jackets, namely, loadout, launching and upending has been studied. The physical modelling can be looked upon both as an adjunct to numerical modelling using computers and also as an independent tool of investigation. The problems of design of models and of experiments are discussed and the prediction equations based on similitude are given.  相似文献   

印度东南部海岸拉梅斯沃勒姆滨外保克湾底层水特征对底栖有孔虫的影响     

Kumar V  高莉玲 《海洋地质前沿》2001,17(12):13-15

有孔虫生活在海洋和半咸水环境。底栖有孔虫的存在很大程度上受物理因素（深度、温度、光量、水体扰动）、化学因素（盐度、溶解氧和可用元素）和生物因素（食物供给量和底层沉积物特征）的制约。研究人员对印度东、西岸现代底栖有孔虫生态学和分布状态进行了研究。Ｎａｉｄｕ等在对Ｖｉｓａｋｈａｐａｔｎａｍ港复合体有孔虫进行分析后提出 ,可以将有孔虫作为海洋污染的指示物。ＳｒｅｅｎｉｖａｓａＲａｏ等采用Ｑ模式系数分析对尼赞伯德讷姆湾有孔虫的分布进行了研究 ,确认此区域存在４种组合 ,受不同环境条件的影响。Ｋｈａｒｅ等对门格…  相似文献   

Experimental study on loss factor for corrugated plates by bandwidth method     

Nirmal Kumar Mandal  Roslan Abd. Rahman  M. Salman Leong 《Ocean Engineering》2004,31(10):1313-1323

The material loss factor for technically orthotropic plates was measured by half-power bandwidth method. Rectangular and trapezoidal corrugated plates of steel were considered. A simple isotropic steel plate was also considered for comparison of the results. The concept of single degree of freedom system was adopted. The tests were undertaken at very low frequency range (0–100) Hz. The plate models were suspended freely with two wires to minimize or prevent excessive extraneous energy dissipation. Out of plane point force, random in nature was applied to the top middle of the plates and the responses were measured from the middle point of the plates by FFT analyzer using miniature small mass accelerometer as sensor. The aim of these tests is to investigate the effects of bending rigidity and mode orders over material loss factor. The values of estimated modal damping loss factors are compared and tabulated for the plates models considered. Natural frequencies of some of the initial modes of the plates are also presented.It is observed that the higher the value of bending rigidity of the plates, the larger the values of loss factor of it. There was a significant increase in value of loss factor in corrugated plates to that of the isotropic plate.  相似文献   

Significance of pteropods in deciphering the late Quaternary sea-level history along the southwestern Indian shelf     

A. Singh  K. Ramachandran  M. Samsuddin  N. Nisha  V. Haneeshkumar 《Geo-Marine Letters》2001,20(4):243-252

The paper evaluates the usefulness of pteropods in palaeobathymetric synthesis along the southwestern continental shelf of India. Core samples collected from the shelf off north Kerala (SW coast of India) were studied for faunal assemblages (pteropods and foraminifers), calcium carbonate contents and lithological characteristics. A fundamental precept for considering any organism as a bathometer is that it should be highly sensitive to changing water depths. To ascertain this, the bathymetric distribution patterns of modern pteropods as well as planktonic and benthic foraminifers were recorded in core-top samples. The results reveal that certain pteropod species (Limacina inflata, Creseis acicula, Creseis virgula, and Creseis chierchiae) are highly depth sensitive. The response of these species to depth changes was assessed in terms of the L. inflata and Creseis spp. abundance ratio. A model for the relationship between water depths and the L. inflata/Creseis spp. ratio is proposed for the southwestern shelf of India. Variations of benthic/planktonic foraminifers (BF/PF) and pteropods/planktonic foraminifers (Pt/PF) in the modern sediments were also found to be depth controlled. Two sediment cores, representing the last 36,000 and 23,000 years, were collected to investigate past sea-level changes. These cores comprised two distinct lithological units, the upper unit corresponding to the Holocene, and the lower unit to the last glacial period. The L. inflata/Creseis spp. model was successfully applied to the fossil record for reconstructing the palaeobathymetry of the shelf study locations. Down-core variations in the BF/PF and Pt/PF ratios support these inferred sea-level changes. Major periods of sea-level oscillations were also found to have a strong influence on the calcium carbonate distribution. For both core sites, the palaeobathymetric curves reflect consistency in terms of changing sea level. The results suggest that the sea level stood around 100 m below the present mean sea level during the last glacial maximum. A rapid rise in sea level was documented between 15 and 10 ka B.P. The sea-level rise has been slower since 7 ka B.P.  相似文献   

Comparison of TOPEX/POSEIDON Altimeter Derived Wind Speed and Wave Parameters with Ocean Buoy Data in the North Indian Ocean   总被引：1，自引：0，他引：1  

Jignesh Kshatriya  Abhijit Sarkar  Raj Kumar 《Marine Geodesy》2001,24(3):131-138

Results of comparison exercises carried out between the state-of-the-art TOPEX/POSEIDON altimeter-derived ocean surface wind speed and ocean wave parameters (significant wave height and wave period) and those measured by a set of ocean data buoys in the North Indian Ocean are presented in this article. Altimeter-derived significant wave height values exhibited rms deviation as small as ±0.3 m, and surface wind speed of ±1.6 m/s. These results are found consistent with those found for the Pacific Ocean. For estimation of ocean wave period, the spectral moments-based semiempirical approach, earlier applied on GEOSAT data, was extended to TOPEX/POSEIDON. For this purpose, distributions of first four years of TOPEX/POSEIDON altimeter data and climatology over the North Indian Ocean were analyzed and a new set of coefficients generated for estimation of wave period. It is shown that wave periods thus estimated from TOPEX/POSEIDON data (for the subsequent two years), when compared with independent data set of ocean data buoys deployed in the North Indian Ocean, exhibit improved accuracy (rms ~ ±1.4 nos) over those determined earlier with GEOSAT data.  相似文献   

3D Reconstrution with Rational Function Model     

V. Nagasubramanian  P. V. Radhadevi  R. Ramachandran  R. Krishnan 《Journal of the Indian Society of Remote Sensing》2008,36(1):27-35

Rational Function Model (RFM) is the alternate sensor Model to the rigorous sensor model that allows end user to perform sensor-independent photogrammetric processing. Nowadays, commercial off-the-shelf (COTS) digital photogrammetric work stations have incorporated RFM as a method for image restitution. It is technically applicable to all types of airborne and space borne sensors. In this paper, we describe the derivations of the algorithmic procedure for third order inverse and forward RFM method for 3-D reconstruction. Model accuracy is evaluated for aerial image, TK-350 Russian image and IRS-1C PAN image. The results ensure that properly constructed RFM are accurate enough to be used in place of the original rigorous models. The test results are reported and summarised.  相似文献   

Urban cadastral mapping using very high resolution remote sensing data     

K. N. Prudhvi Raju  Sarvajeet Kumar  Kshitij Mohan  Manish Kumar Pandey 《Journal of the Indian Society of Remote Sensing》2008,36(3):283-288

With growing urban expanses, one of the pre-requisites for effective governance is Urban Information Systems (UIS) with content down to individual properties (and individuals). The basic input i.e., a map, in UIS should show individual property boundaries showing the plan outline of all structures existing within, at a scale of 1:1000 and larger with sub-metre to centimeters planimetric and geometric accuracy. With very high resolution remote sensing data of the order of 1m available in hand, it is possible to prepare maps with high resolution spatial content. The present exercise demonstrates a method of preparing a geometrically and planimetrically accurate urban cadastral map on very large scale for a small area of about 5 sq km. IKONOS merged data with 1m resolution is used for the purpose. Mapping was done in conjunction with on-site measurements and sketches. Guides are used to maintain shape symmetry and accuracy of buildings and other features. Working out cost of mapping per unit area is another objective in the present exercise. For want of fully or semi-automatic methods of information extraction from very high resolution remote sensing data, it is imperative that mapping should be carried out in conjunction with some on-site measurements wherever necessary.  相似文献   

Geochemical Eccentricity of Ground Water Allied to Weathering of Basalts from the Deccan Volcanic Province,India: Insinuation on CO<Subscript>2</Subscript> Consumption     

N. J. Pawar  J. B. Pawar  Suyash Kumar  Ashwini Supekar 《Aquatic Geochemistry》2008,14(1):41-71

Analyses of 72 samples from Upper Panjhara basin in the northern part of Deccan Plateau, India, indicate that geochemical incongruity of groundwater is largely a function of mineral composition of the basaltic lithology. Higher proportion of alkaline earth elements to total cations and HCO₃>Cl + SO₄ reflect weathering of primary silicates as chief source of ions. Inputs of Cl, SO₄, and NO₃ are related to rainfall and localized anthropogenic factors. Groundwater from recharge area representing Ca + Mg–HCO₃ type progressively evolves to Ca + Na–HCO₃ and Na–Ca–HCO₃ class along flow direction replicates the role of cation exchange and precipitation processes. While the post-monsoon chemistry is controlled by silicate mineral dissolution + cation exchange reactions, pre-monsoon variability is attributable chiefly to precipitation reactions + anthropogenic factors. Positive correlations between Mg vs HCO₃ and Ca + Mg vs HCO₃ supports selective dissolution of olivine and pyroxene as dominant process in post-monsoon followed by dissolution of plagioclase feldspar and secondary carbonates. The pre-monsoon data however, points toward the dissolution of plagioclase and precipitation of CaCO₃ supported by improved correlation coefficients between Na + Ca vs HCO₃ and negative correlation of Ca vs HCO₃, respectively. It is proposed that the eccentricity in the composition of groundwater from the Panjhara basin is a function of selective dissolution of olivine > pyroxene followed by plagioclase feldspar. The data suggest siallitization (L < R and R _k) as dominant mechanism of chemical weathering of basalts, stimulating monosiallitic (kaolinite) and bisiallitic (montmorillonite) products. The chemical denudation rates for Panjhara basin worked out separately for the ground and surface water component range from 6.98 to 36.65 tons/km²/yr, respectively. The values of the CO₂ consumption rates range between 0.18 × 10⁶ mol//km²/yr (groundwater) and 0.9 × 10⁶ mol/km²/yr (surface water), which indicates that the groundwater forms a considerable fraction of CO₂ consumption, an inference, that is, not taken into contemplation in most of the studies.  相似文献